![]() Connect a wireless client or laptop to CiscoAirprovision- SSID with PSK = password. To configure the EWC using the over-the-air setup wizard, perform the following steps: Wait for approximately 5 minutes and observe the access point LED until it turns solid green and the access point starts to broadcast the CiscoAirprovision- SSID.ĭay 0 – provisioning using the over-the-air setup wizard The following is an example of the switch port: Also note that management traffic is untagged, and if a VLAN is being used for management, it should be configured as a native VLAN on the switch port. If multiple VLANs are being used for client traffic, the switch port should be configured to trunk the VLANs. The switch port to which the 9100 access point is connected can be a trunk port or an access port. Connect and power up the EWC-capable access point. To connect an EWC-capable access point to a 9100 access point, perform the following steps: All APs joining to EWC network should have minimum of 8.10.X or 16.12.X code.If you intend to use 802.1X authentication, you need to have a RADIUS/Authentication, Authorization, and Accounting (AAA) server.Alternatively, you can use a mobile device or tablet with the Cisco Catalyst Wireless application installed to configure and provision the EWC. You will need a Wi-Fi-enabled laptop to connect to the predefined CiscoAirProvision- SSID for provisioning and configuring the EWC.You can also connect multiple Cisco Catalyst 9100 Access Points running the EWC to the switch. This AP must support Cisco EWC functionality. The switch to which the access points connect has a configuration similar to the following:ĭescription > Employee Network > Guest Network > Management and EWC Network > Connected to EWC AP.zip file (unzipped) on the TFTP server. The WLANs can be mapped to VLANs trunked on the switch port.Īll access points, including the active AP in a EWC network, should be in the same Layer 2 broadcast domain. On an EWC network, up to 16 WLANs can be configured. ![]() It is configured with the security type, Quality of Service (QoS), radio policies, and other wireless network parameters. The management interface must be configured and is used for in-band management: web UI, Telnet/SSH Command-Line Interface (CLI), or telemetry and programmable interface with NETCONF/YANG.Ī WLAN associates a Service Set Identifier (SSID) to VLANs. 1x 100, 1000, 2500, or 5000 Multigigabit Ethernet (RJ-45) – IEEE 802.3bzĪn interface is a logical entity on an EWC.Two RJ-45 ports are available on the 9100 access points: Cisco Identity Services Engine (ISE) 2.3, 2.4, 2.5 and later releaseĪ port is a physical entity used to connect Cisco Catalyst 9100 Access Points to the network.Cisco Connected Mobile Experiences (CMX) 10.6, Cisco Spaces.Cisco DNA Center 1.3.3 and later release.Access points supported as subordinate APsĬisco EWC on Catalyst Access Points is supported beginning with Release 16.12.2s.Ĭisco EWC can interoperate with the following: ![]()
0 Comments
Leave a Reply. |